The Tie Interceptor

The Tie Interceptor is very similar to the Tie Fighter that I created on my first attempt, the cockpit design for the Interceptor is the exact same as the Fighter minus the canon positions as they are on the wings instead of the underside of the cockpit.

I made the same base structure as before withe a different wing shape, this time using the cut tool to point out and bend the wings into the Interceptor's signature shape.

Extruding the black panels onto each wing was a massive pain, it ended up causing massive problems with panels being not only inverted but also it automatically replicating panels, removing panels and also not allowing me to fill in holes. An online search told me several options that I could try but unfortunately nothing worked, after messing around with the detach and reattach features of different faces, the model allowed me to finally fill some holes and finish the extruded detail on the wings.

In the picture above is one of the voids that I wasn't able to fill until I had messed around with other faces nearby, I think the problem was to do with the whole wing being made from a single cube shape and being manipulated to not only be bent but also be a totally different shape with a large gap in the center.

After looking at different photos of Tie Interceptors, the cannons were sneakily hid into the wing design by what looked like a long pipe being tucked away under the extruded panels and being welded to the wings points.